UNLOADED 2 SHAFT PULL BAR -- DOES NOT come with Rod End or Tube.
HMS Unloaded 2 Shaft Pull Bar is a 6 biscuits bar, custom built with 4 on the acceleration side and 2 on the braking side of pull bar. Easy to adjust the preload, long lasting biscuits.
This 2 shaft bar will always keep a positive load on the biscuits so this will make for a smoother pull bar.
Our Biscuits will give lower rebound rate which will help keep car tighter on entry.
Approximately 1" of travel on acceleration.
Each Pull Bar comes with a Build Sheet with Load Ratings.
**Please enter your center to center measurement in the 'NOTE' text box. And In the 'Notes' text box please tell us about your car - engine, tires, etc.
Check some other products that work very well with this pull bar Quick Change Pull Bar Plates , Pull Bar Drive Shaft Loop , 9 inch Ford Pull Bar Mount Kit ,Pull Bar Adjuster , or Quick Adjust Pucks
We also have a tool for holding the pull bar so you can remove the bushings easily Hammond Motorsports Pull Bar Holder This hold will only work on the HMS pull bars the older JDM are not set up for this
