Ready to bolt in. HMS Pro Series Pull Bar is a 6 biscuits bar, custom built with 4 on the acceleration side and 2 on the braking side of pull bar. Easy to adjust the preload, long lasting biscuits. We manufacture this all inhouse but the biscuits.
Some of the up grades that Hammond Motorsports has done is FK Teflon rod ends , Swift ground stainless steel shafts , machining shaft to housing bushings , made holder to use in holding of the pull bar to take apart or rebuild with, DO a brake in of bushings before hand , dyno all bars , made the windows on housing smaller to keep dirt out.
Our Biscuits will give lower rebound rate which will help keep car tighter on entry.
Approximately 1" of travel on acceleration.
Each Pull Bar comes with a Build Sheet with Load Ratings.
To order a loaded HMS Pull Bar you will need to get a center to center measurement of the pull bar. That is center of rod end to the center of the rod end.
**Please enter your center to center measurement in the 'Length' text box. In the 'Notes' text box please tell us about your car - engine, tires, etc.
Check some other products that work very well with this pull bar Quick Change Pull Bar Plates , Pull Bar Drive Shaft Loop , 9 inch Ford Pull Bar Mount Kit ,Pull Bar Adjuster , or Quick Adjust Pucks
We also have a tool for holding the pull bar so you can remove the bushings easily Hammond Motorsports Pull Bar Holder This hold will only work on the HMS pull bars the older JDM are not set up for this
MADE IN THE U.S.A
1 Review Hide Reviews Show Reviews
-
HMS Loaded Pullbar
Comes as advertised, ready to slap in and race. Comes with a sheet that tells you exactly how your pullbar is set up, which is great when you need a quick reference when doing maintenance on your pullbar. It really is a nice piece of equipment, can't wait to see how it works this weekend
