This is our deluxe kit with everything you need.
- 4 Chassis Plates
- 8 Rod End Reducers
- 4 Bolts
- 4 Nuts
- 8 Washers
- 2 Back Braces
The measurement on the plates from the 2x2 square cut to the 1 1/2 round cut out is 16.
Dave's Tip - "Before you weld this kit in place add a .040 spacer between the rod end reducer and the plate. Adding .040 will give you a little extra spacing. After welding the plates will shrink, this way you can move the bars easy. You can make the .040 spacer out of an old body panel."